1 砼配合比及攪拌
1.1 施工前必須對砼路面用的砂、石、水泥鋼筋等原材料取樣試驗分析，并通過試驗得出
砼配合比數據報告；同時復核平面和高程，檢查模板位置和高程，使之符合國家有關標準、
規范的規定。
1.2 施工前必須對砼路面基層進行復查，各項技術指標均應合符國家標準、規范的規定。
1.3 材料要求
1.3.1 水泥：水泥進場必須有產品合格證及化驗單，并對品種、標號、包裝、出石日期進
行檢查，不同標號、廠牌、品種、出廠日期的水泥不能混合堆放和混合使用，出廠日期超過
三個月或受潮水泥須經試驗確定標號。
1.3.2 砂：應采用潔凈、堅硬、符合級配要求，細度模數在2.5 能上能下的中、粗砂；條
件限制時可采用含泥量不于2%的細砂。
1.3.3 碎（礫）石：質地堅硬無風化，符合級配要求，最大粒徑不超過40mm，其余指標
均應符合有關的規定。
1.3.4 混凝土攪拌及養護用水應采用清潔飲用水或經化驗符合要求之水源。
1.3.5 外加劑：應按規定選用，并應經配合比試驗符合要求后方可使用。
1.3.6 砼、板及鋼筋：品種、規格要符合設計要求；鋼筋應順直、無裂傷、刻痕，表面油
污及銹蝕應清除。
1.4 混凝土的配合比應通過計算及試驗室試配確定，其水灰比不大于0.50，單位水泥用量
不小于300kg/m3，塌落度宜為10-25mm。施工中應測定現場骨料的含水率，將A concrete mix and mixing
1.1 Construction of concrete road surface must be used before the sand, stone, cement, steel and other raw materials, sample test analysis, obtained by test
Concrete mix data reports; the same time review of plane and elevation, check the template location and elevation, to conform to the relevant national standards,
Specification requirements.
1.2 Construction of the concrete road base before its review, the technical indicators shall comply with national standards, norms.
1.3 Material requirements
1.3.1 Cement: Cement approach must have a product certificate and testing orders, and species, labeling, packaging, out of date into the stone
For inspection, different labels, brands, variety, mix the cement factory date stacking and mixed use, date of production over
Three months or be subject to tests to determine grade damp cement.
1.3.2 sand: should be clean, hard, meet the grading requirements, fineness modulus of 2.5 at higher or lower in the middle, coarse sand; article
Conditions limit the mud can be used not at 2% of the sand.
1.3.3 broken (gravel) rock: hard texture, no morals, meet the gradation requirements, the maximum size of not more than 40mm, other indexes
Shall meet the requirements.
1.3.4 concrete mixing and curing water should be clean drinking water or meet the requirements of the water testing.
1.3.5 Admixtures: should be required to use, and should meet the requirements by the mixture ratio test before use.
1.3.6 Concrete, steel plate and: varieties, specifications to meet the design requirements; bar should be straight, no tear, nicks, surface oil
Pollution and corrosion should be removed.
1.4 Concrete mix should be calculated and determined with laboratory test, the water-cement ratio is not greater than 0.50, the unit amount of cement
Not less than 300kg/m3, slump should the 10-25mm. Construction site should be measured moisture content of aggregate, will

前往下載