交底內容：
1. 本工程道路側平石是按照道路側平石大樣圖（圖號為D-15施）進行施工。
2. 本工程道路側平石使用材料是：包括人行道側石及綠化帶側石，人行道側石規格為100×35×15cm，綠化帶側石100×15×30cm；平石規格為100×25×12cm。
3. 測量放線：
（1） 本工程側平石利用6%水泥石屑穩定層施工中兩側自然寬出的多余部分作為基礎墊層。
（2） 路面中線校核后，在路面邊緣與側平石交界處放出側平石線，直線部位10m一樁，曲線部位5~10m，路口及分隔帶、安全島等圓弧，1~5m也可用皮尺畫圓并在樁上標明側平石頂面標高。
4. 刨槽：
按樁的位置打白灰線，以線為準，按設計要求寬度向外刨槽�？拷�路面一側，比線位寬出少許，一般不大于5cm。刨槽深度可比設計加深1~2cm，以保證基礎厚度，槽底要
Cards on the table contents:
1. This project is in accordance with road side road side flat rock flat rock bulk sample (Figure No. D-15 facilities) for construction.
2. The project road side of the flat stone used materials include: sidewalk side of the stone and green with side stones, sidewalk side of the stone size is 100 × 35 × 15cm, green with a side of stone 100 × 15 × 30cm; square stone size was 100 × 25 × 12cm .
3. Measure for:
(1) The engineering side of the flat stone with 6% cement stabilization layer of stone chips on both sides of the construction of the excess part of the natural width of a cushion as a basis.
(2) After checking the road center line, edge and side of the road flat stone at the junction of the side flat stone line release, a 10m straight line position, the curve part 5 ~ 10m, road junctions and medians, pedestrian refuges arc, 1 ~ 5m tape can also be used Pile on a circle marked in the top side of flat stone elevation.
4. Routers:
Position by playing white ash pile line to line as, by design width of the outside router. Near the road side, than the line out a little bit wide, generally not more than 5cm. Router design better than the depth of 1 ~ 2cm, to ensure that the basis of thickness, bottom to
 

前往下載